Wood/Chuck WRT Self Propelled Chippers

WRT

GENERAL SPECIFICATIONS

Weight: 4,200 lbs.* (Varies with options and engine selection) Does not include OEM installations.
Length : 14'6"
Width: 62'
Height: 8'2"
OEM Installation Capacity: 5000 lbs.

HYDRAULIC TANK

Hydraulic tank shall be a 24-gallon minimum capacity, all steel construction with baffle, sight gauge. Tank shall have a drain plug and mesh strainer at filler opening.

HYDRAULIC HOSE

All high-pressure hydraulic hoses shall be 3000-psi industrial grade construction with wear spray guards in applicable areas. All hydraulic hoses are SAE 'standard straight thread fitting ends for easy replacement or repair.

CHASSIS FRAME

2" x 6" steel tubing with 3/8" wall.

HYDRAULIC FILTRATION SYSTEM

Filtration system shall consist of a 10-micron spin-on return line filter with restriction bypass located in the hydraulic tank.

PAINT

Entire unit degreased, epoxy primed and finished painted for complete rust protection.

AXLE

Axles shall be fabricated steel with four (4) Hydraulic Drive Motors conveying 80 Horsepower. Front axle shall be pivot mounted and the rear rigid.

TRAILER BRAKES (Tow Trailer Only)

Trailer brakes shall be 12-volt, self-adjusting type.

BREAKAWAY SWITCH (Tow Trailer Only)

Breakaway switch shall be 12-volt type, enclosed with steel housing for protection.

TIRES

Tires shall be two (4) 21 ply pneumatic tires.

CONTROLS

Single handle joystick with safety switch activation on control stick and seat. Proportional valving shall insure accurate control.

SAFETY CHAINS (Tow Trailer Only)

Safety chain shall be two (2) independent 3 ft. long x 3/8" thick with slip hook.

TOW BAR (Tow Trailer Only)

Tow bar shall be fixed steel. Pintle ring shall be 2-1/2" I.D. minimum (or ball hitch) adjustable for height.

FUEL TANK

Fuel tank shall be 24-gallon minimum tank.

LIGHTING (Tow Trailer Only)

Lighting shall conform to all D.O.T. specifications. Tail light package shall be a 12-volt, hermetically sealed system, shock mounted to frame with grommets. Brake and turn lights shall be located at the rear sides of the infeed chute and shall be flush mounted to the frame for protection. All wiring shall be protected within anon-corrosive, abrasion resistant, shielded loom. All connections shall be ultrasonically spliced within the wiring harness.

Battery box shall be a 14 gauge steel construction that is lockable and mounted directly to frame.

DRIVE SYSTEM

Powerful full time four wheel drive via four Geroller Type motors and Hydrostatically powered through an Eaton Hydrostatic Transmission. The system incorporates the patent pending differential "Turf Guard" that reduces the damage to the turf during transit.

WRT BRAKE SYSTEM

Heavy Duty 4 wheel disc brakes that are hydraulically activated with a nitrogen charged accumulator to provide redundancy in the event of hydraulic power failure. Parking brakes are cable controlled from the cab of the WRT.

TONGUE WEIGHT (Tow Trailer Only)

Tongue weight shall be 250 lb. average (may vary)

CAB

Heavy duty ROPS protection with front entry only. Top, sides and rear protection for the operator from outside interference and to provide containment.

Wood/Chuck reserves the right to improve products and the right to change, amend or delete specifications, at any time, without notice or obligation.